Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: If any parts are missing, do not
attempt to plug in the power cord and turn
"ON" the machine. The machine should only
be turned "ON" after all the parts have been
obtained and installed correctly.
MOUNTING ON/OFF SWITCH BRACKET TO THE
UP POSITION
1. This jointer comes with the on/off switch
bracket (Fig. 4-A) assembled upside down to
protect it during transport. Unbolt the switch
bracket at the rear of the jointer by removing
the 2 cap screws (B), pivot the bracket 180º and
refasten the switch bracket using the same 2
caps crews, see Fig. 5.
Fig. 4
ASSEMBLING FENCE TO REAR OF CABINET
1. Assemble the fence
(A) Fig. 6 to the rear of
the cabinet by align-
ing the fence mount-
ing holes with the
holes in the cabinet,
fasten the fence us-
ing 2 cap screws and
washers (B).
OPERATING CONTROLS & ADJUSTMENTS
TURNING JOINTER ON & OFF
The On/Off switch is conveniently located on
a post, behind the jointer fence, for easy ac-
cessibility. To start the jointer, press the start
button (A) Fig. 7, and to stop the jointer, press
the stop button (B).
22
Fig. 5
Fig. 6
Fig. 7
FENCE OPERATION
MOVING FENCE FORWARD OR BACKWARD
The fence (A) Fig. 8, can be positioned any-
where across the table by loosening lock lever
(B) and rotating handwheel (C). Once the fence
is moved to its desired position, retighten lock
lever (B) securely. As the fence (A) is moved
across the table, the sliding portion of the col-
umn (D) protects you from the cutterhead dur-
ing operations.
Fig. 8
TILTING THE FENCE
To tilt the fence (A) Fig.9 to the right or to the
left, loosen lock handle (B), move the fence to
the desired angle and tighten lock handle (B)
securely.
Fig. 9
NOTE: When tilting the fence to the right (out-
ward), the stop plate (C) must be rotated to the
up position in order to allow the fence to go
past it.
IMPORTANT: When cutting a bevel, it is recom-
mended whenever possible to tilt the fence
towards the table. The fence will then form a
V-shape with the tables, and the work is easily
pressed into the pocket while passing it across
the knives.
ADJUSTING FENCE POSITIVE STOPS
The fence on your jointer is equipped with pos-
itive stops at the most common fence positions
(90º & 45º right and left). To check and adjust
the positive stops, proceed as follows:
1. Position the fence 90º to the table making
Publicidad
Tabla de contenido
