Chicco Next2me Dream Manual Del Usuario página 13

WARNING: When covering or removing the cover, take care
when handling the fabric parts so as to avoid accidental tears
or damage.
DOING THE BED
It is possible to unfasten the crib from the parents' bed when
doing the bed. Just unfasten the grey buckles under the fabric
lining.
When fastening the crib again to the parents' bed, pull the
straps again to make sure that the crib is correctly and securely
fastened to the parents' bed. Make sure that all the steps
illustrated above in "Co-sleeping configuration (fastened to the
bed)" have been completed.
HOW TO REMOVE THE FABRIC COVER
1. Remove the mattress and unfasten the buttons in the lower
part of the fabric following the procedure illustrated in
"ASSEMBLY OF THE CRIB" in opposite order.
2. Open the 3 zippers "E3" on the upper structure "B" and
unfasten the 4 buttons fastening the fabric to the upper
structure.
3. Press the buttons on the fasteners of the feet, turn the upper
bar structure up and pull the upper structure out of the feet
(fig.26A-B)
4. Then remove the fabric lining.
DISASSEMBLING THE CRIB:
The crib can be disassembled completely to put it away in
the supplied bag. In order to complete the disassembly of the
crib after removing the fabric, remove the lower bar and the
central support structure by repeating the steps illustrated in
"ASSEMBLY OF THE CRIB. "
ROCKING CONFIGURATION
To use rocking configuration:
1. Pull out the slides "A2" on the lower part of the feet of the
crib positioning the foot near the centre of the top of each
slide and, holding the upper edge of the crib with your hand,
pull the crib up while holding the crib down with your foot
(fig.27).
2. Repeat the same operation for both sides.
3. To deactivate rocking configuration, just press the button "A7"
at the centre of the slide on each side and then accompany
the crib down holding by the upper edge so that the slide
returns to closed position (fig.28). Always make sure that the
slide has returned to closed position.
WARNING:
Always remember
configuration when using the product in "co-sleeping (fastened
to the bed)" or when the child is unattended.
WARNING: It is not possible to select different heights on the
two sides of the crib when in rocking configuration.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case of
damages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please refer
to the specific provisions of national laws applicable in the
country of purchase, where provided.
to deactivate rocking
13