Memory Functions; Care And Maintenance - Nissei DS-137 Manual De Instrucciones

The measured data will automatically be stored in the memory. When a
measurement resulted in an error, it will not be stored.
8 Press ON/OFF BUTTON
If you forget to turn off the unit, it will be automatically turned off after 3
minutes.

MEMORY FUNCTIONS

The memory can store up to 30 measurements and their average. When the number of
measurements exceeds 30, the oldest data will be replaced by the newest data.
Recalling measured data
1 Press MEMORY BUTTON
When no measurements are stored, nothing will be displayed.
The memory data is displayed for approximately 5 seconds. Approximately 5 seconds
after MEMORY BUTTON
current measurement display.
2
Press MEMORY BUTTON
Every depression of the key switches among the memory data.
3
Press ON/OFF BUTTON

CARE AND MAINTENANCE

Because the unit includes precision parts, care should be taken to
avoid extreme temperature variations, humidity, shock, dust, and
direct sunlight. Do not drop or strike the unit. Make sure not to expose
the unit to moisture. This unit is not water resistant.
Use only a soft, dry cloth to clean the unit. Do not use gasoline, paint
thinner, or other strong solvents on the unit. Since the cuff may absorb
perspiration and other fluids, inspect it for stain and discoloration after
each use. When cleaning the cuff, do not machine wash or scrub it.
Use a synthetic detergent and gently rub the surface. Make sure fluid
never gets in AIR HOSE . Air dry throughly.
12
When storing the unit, do not place heavy objects on it and do not coil
Refer to "PARTS NAMES AND PRODUCT COMPONENTS" on page 2 for circled numbers:
2 to turn off the power.
to see stored data.
3
is released, the apparatus will turn off or return to the
3
3 to move to next stored data.
and turn off the unit.
2
Do
measurements for congestion
of blood could result in false
measurement. Let your arm
rest for at least 5 minutes.
AIR HOSE too tightly. When the unit has been stored at a temperature
below the freezing point, keep it for at least 1 hour in a warm place
before using it. Remove the batteries if the instrument is to be stored
for an extended period of time. Keep the batteries out of reach
of children.
We suggest that you have your blood pressure monitor checked
every 2 years. This operation may only be performed by the
manufacturer or by firms authorized by the manufacturer.
Do not inflate the cuff when it is not wrapped around your arm.
Do not disassemble or modify the unit.
- 11 -
MEASUREMENT PROCEDURES
not excute repeated
see fig.5
Storage cannot be cancelled.
The stored data will be retained
even after the power is turned off.
The stored data will be lost
after battery replacement.
While MEMORY BUTTON
3
for approximately 2 seconds, the memory
data numbers will be fast-forwarded to
the average of total stored data unless
the button is released; the number stops
at release of the button.
GASOLINE
PAINT
THINNER
~
1 15
page 6
is held down