Lighting The Burners - IO Mabe IO6004I PM02 Manual De Instrucciones

instructions for use:
The hob control area houses the devices and knobs for operation of
the gas burners and/or the electric hot plates.
operation of gas burners
The burner regulation knobs can be turned anticlockwise from the
closing position to the widest open position and vice versa in the
opposite direction (put the needle to the required position):
sin suministro de gas
máximo suministro de gas
mínimo suministro de gas

lighting the burners

For models equipped with electrical ignition device, the ignition of
burners takes place by pressing and rotating the knob until the position
of maximum output is reached. In the versions with separate ignition
key, only press this key and at the same time press and rotate the
knob proportional to the desired burner, until it reaches the position
of maximum output.
For versions without electric lighting (or if there is a power cut) perform
the operations described using a match or lighter to light the gas. (in
such an event, pay the utmost attention not to burn yourself).
For models with safety valve keep the knob pressed for about 3-4
seconds until the device keeps the flame alight automatically. The safety
valve operates when the flame is turned off accidentally, stopping the
supply of gas (e.g. in draughts, spills of liquid, etc.). The ignition device
shouldn't anyhow be operated for more than 15 seconds. If a burner
is turned off accidentally or does not light, turn the control knob OFF
and repeat the lighting after at least 1 minute.
When the burner is lit adjust the flame as required. To turn the gas
supply OFF turn the knob clockwise to the << >> position.
4