Mounting Options; Wiring Options - Broan LOSONE SELECT L900L Manual De Instrucciones

MOUNTING OPTIONS

¼-20 hex nuts secure mounting brackets to housing. Loosen and
re-tighten or remove and replace nuts as necessary for desired
mounting bracket position.
Factory-Shipped
Straight-Through
y yyy
Discharge
22"
Mounting brackets in
factory-shipped position -
mounted directly to joists.
(Outlet parallel to joists.)
(New construction)
Housing
Converted to
Right-Angle
Discharge
yyyyyyyyy
18"
Mounting brackets flipped
over and mounted to
additional framing.
(Outlet vertical.)
(New or Existing construction)

WIRING OPTIONS

WIRING PLATE
POSITION
HORIZONTAL POWER
CABLE CONNECTION
Wiring plate mounts to side or top of housing.
@@@ @@@ @@@ @@@ @@@ @@@ yyy @@ @@ @@ @@ @@ @@ yy
@@@ @@@ yyy @@@ @@@ @@@ @@@
Factory-Shipped
Straight-Through
1 1 / "
8
Discharge
MAX.
yyyyyyyyy
18"
Mounting brackets flipped
over and mounted to
additional framing.
(Outlet perpendicular to joists.)
(New or Existing construction)
1½"
Factory-Shipped
to
Straight-Through
yyy
2½"
Discharge
22"
Mounting brackets flipped
over and mounted to top of
housing. Housing secured
with cables.
(Outlet parallel to joists.)
(New or Existing construction)
VERTICAL
POWER
CABLE
CONNECTION
DUCTING OPTIONS
BLOWER DISCHARGE POSITIONS
MOVABLE
PANEL
1½"
to
2½"
DUCT
CONNECTOR
(intake)
Ventilator shown in
straight-through discharge
position. (Factory shipped)
DUCTING (Vertical blower discharge)
yyy
8" X 12" TO
12" ROUND TRANSITIONS
12" ROUND
DUCT
Typical ductwork connection to a ventilator converted to
USE AND CARE
Ventilator is designed for continuous operation. If desired, it may be
controlled using an on/off switch or a solid-state, variable speed
control. Follow wiring instructions packed with control, and adhere
to all local and state codes, and the National Electrical Code.
WARNING: To reduce the risk of electric shock,
disconnect from power supply before servicing.
To clean blower assembly: Remove access panel, unplug blower
from housing, remove blower mounting nuts, and carefully remove
blower from housing. Use appropriate vacuum attachment or a soft
cloth and mild soap or detergent to clean blower discharge area
and wheel. DO NOT ALLOW WATER TO ENTER MOTOR. Make
sure blower assembly is completely dry before reinstalling.
Motor is permanently lubricated. Do not oil or disassemble motor.
MODELS • L900L • L1500L
DUCT
Housing
CONNECTOR
rotated &
(outlet)
movable panel
covers previous
open side.
DUCT
CONNECTOR
(intake)
Ventilator shown in right-
angle discharge position.
(Change movable panel to
new location as shown.)
right-angle discharge.
Page 3
DUCT
CONNECTOR
(outlet)
MOVABLE
PANEL
(Change to this
location)
ROOF CAP
12" ROUND
DUCT