TROUBLESHOOTING
PROBLEM
1. The gas cylinder is frosted over.
2. The openings are blocked.
3. The control knob is not in the "ON"
The burner will
not ignite.
4. There may be too many glass beads
The burner flame
1. The gas pressure is low.
is too low.
2. The cylinder is less than 1/4 full.
1. There is dirt or film on the reflector
Carbon build-up
and/or thick black
2. The burner is blocked.
smoke is present.
POSSIBLE CAUSE
position.
covering the burner bowl or small
pieces may be blocking the burner
ports.
and burner screen.
1. Wait until gas cylinder warms up
and becomes unfrosted.
2. Clear the blockage.
3. Turn the control knob to the "ON"
position.
4. Remove a portion of the glass beads.
Make sure the glass beads just cover
the upper surface of the burner.
1. Turn the cylinder valve off and
replace the cylinder. Check the
burner ports for blockage.
2. Use a full gas cylinder.
1. Clean the reflector and burner
screen.
2. Remove any blockage and clean
the burner inside and outside.
13
CORRECTIVE ACTION