Maintenance; Cleaning And Care; Air Filter - Truper COMP-24S Instructivo

Cleaning and care

• Disconnect the equipment from the power supply and
release all the pressure from the system before trying to
install, servicing, relocate or carry out maintenance.
• Always have the vents clean and free of obstructions to
guarantee an adequate motor cooling.
• Inspect regularly all the mounting screws and double
check for tightness. If any of the screws is lose, tighten
immediately.
Safety valve
• Check the safety valve before each use.
• Wear safety eyeglasses.
• Turn ON the compressor and allow the tank to fill.
• When the compressor shuts OFF automatically, press
the ON / OFF switch into the OFF position (O)
• Pull the safety valve ring a few seconds to release air.
ALWAYS put your face away from the air stream. Release
the ring.
• If air is leaking before releasing the ring, DO NOT use
the compressor and go to a
Authorized Service Center to replace the safety valve.
DANGER
• Using the compressor with a valve in
bad repair may result in death or severe body injuries.

Maintenance

• After each use, disconnect the compressor and release
the air pressure from the tank by pulling the safety valve
ring (A).
After releasing all pressure, open the drain valve (B) to
remove the water stored in the tank by condensation.
Service
• Any other service or repair to the compressor shall be
carried out in a
Center. Service and maintenance carry out by
non-certified people may cause personal injuries and
make the Warranty void.
8
ENGLISH

Air filter

• Check the air filter frequently. Double check it is clean.
• To service the filter, remove the filter cover.
• Remove the filter and clean the sponge or filter with hot
and soapy water (paper filters cannot be washed). Rinse
and let dry.
• Replace the air filters if not possible to wash.
• Set the filter back in the housing base and set the cover.
Authorized Service
Maintenance
A
B