Heat Function - ALFA living DUETTINO INDOOR Manual Del Usuario

ABOUT THE CHIMNEY
- The exit of smoke from the wood-fired oven has a diameter of 150 mm.
- By law, the chimney flue must serve only one thermal device and connecting more than one device to it may
compromise the regular dispersal of smoke.
- A well-constructed chimney flue should not contain too many joints or curves. Hairpin turns at angles greater
than 45° are to be absolutely avoided for the correct dispersal of smoke.
- We recommend the use of an air damper to obtain the maximum efficiency of the appliance.
HOW THE OVEN IS MADE
- The refractory stones inside the oven can be easily taken out to make
the Duettino lighter and therefore easier to move. After placing the oven
in position, place the refractory stones back inside the cooking chamber,
lower, Oven Flame and upper, Oven Brick.
- The Oven Flame contains 12 stones distributed into 2 layers, each 3 cm
thick.
- The Oven Brick contains 15 stones distributed into 3 layers, each 3 cm
thick.
- The Oven Brick is also equipped with a useful second Sliding Deck
in stainless steel: insert the deck by sliding it in between the lateral
guides. The sliding deck, when pulled out half way, makes it easier to
insert dishes for cooking.
- Follow the numbering in sequence when inserting the refractory stones:
repeat the step for each layer of the refractory deck
- Although the refractory stones are very resistant to high temperatures,
they are fragile and easily broken if struck or dropped: handle the
stones with great care.
The cooking decks have been designed to ensure easy assembly: the small space around the perimeter of the
refractory deck is necessary for the insertion of the stones.

HEAT FUNCTION

The Duettino oven is also a hot air thermo-fireplace. When the
vents are turned on, hot air flows into the environment.
It is also possible to convey hot air in an adjacent environment
by connecting a conduit to the vent in the rear of the oven. The
diameter of the exit nozzle is equal to 120 mm.
All operations related to the realization of the electrical
connections, put into service and verifying of the proper
operation must be performed by qualified personnel, using
suitable equipment with power off, carefully following the
current norms. The power cable can be replaced only by a
qualified technician.
To guarantee the safety of people it is necessary to respect the
norms regarding the grounding wire.
The Company is not liable for damages due to incorrect
connections or improper use of the device.
EN
15