Logan PRO JOINER Manual De Instruccion página 5

Instruction Manual
Preparation continued
B. Set V-nail Spacing
1. Read dimension from vise scale (Fig. 7).
2. Adjust V-nail block in slider to same dimension as vise
scale. V-nails are now set approximately 1/4 inch from
each end of joint (Fig. 8).
3. Replace slider.
V-nail Corner Spacing Stop
• Locate slider against the stop by pushing it back as far
as it will go.
• This stop changes the distance the top V-nail is located
from the end of the joint (Dimension X) (Fig. 9).
Using 1/2 inch or smaller moulding
• Only one V-nail block is moveable and it is designed to
be removed from the slider.
• When small mouldings need to be joined. Simply remove
the stop knob from end of slider and slide V-nail block
out. It cannot be left in slider or damage may occur.
• This now allows you to drive two V-nails (one at a time in
different places) to have a secure joint.
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO JOINER
Fig. 9
Model F300-2
Fig. 7
Fig. 8
4