Assembly Procedure - Logan PRO JOINER Manual De Instruccion

Tabla de contenido

Publicidad

Instruction Manual

Assembly Procedure

A. Extension Arms
1. Align set of holes in arm with holes in vise, making sure
the rubber bumper faces up. (Fig. 1).
2. Attach arm to vise with extension arm screws using
extension wrench supplied.
Preparation
A. Clamp Moulding
• Mark edges of mitre to blend any gaps in
joint (Fig. 2). Use wood stain marker avail-
able at hardware store.
• Glue moulding mitre for long lasting solid
corners (Fig. 3).
• Always start by placing longer length in vise on
right hand side and shorter length on left hand
side. This will give you two halves of frame,
eliminating errors (Fig. 4).
1. Remove V-nail slider.
2. Press vise down and tighten vise stop to
provide clearance for moulding.
3. Adjust clamp jaw by pressing spring
button and sliding handle (Fig. 5).
4. Align moulding pieces in vise so top
corner is square (Fig. 6).
5. Tighten handle only as much as
necessary to hold joint together.
6. Release vise stop.
3
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO JOINER
Model F300-2
Fig. 1
Fig. 3
Fig. 4
Fig. 6
Fig. 2
Fig. 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

F300-2

Tabla de contenido