Braun Oral-B OxyJet Center OC 17 565 X Manual Del Usuario página 8

®
Using the OxyJet irrigator
Before using for the first time, fill the water container and allow
the water to run through completely by holding the irrigator
handle over a washbasin.
1.
Attach one of the irrigator jets to the handle until it locks into
place. Fill the water container with water and add mouthwash,
if desired.
2.
Turn on the irrigator by pressing the on/off switch. (When
doing so, the handle switch should be in the lower position =
water stop).
3.
Select the water pressure with the pressure control dial
(1 = gentle, 5 = strong). We recommend that you start with
setting 1, especially if your gums tend to bleed or if children
are using the irrigator.
4.
Bend over a washbasin and guide the jet to your teeth and
gums. Slide the handle switch up to start the water stream.
Keep your mouth slightly open to allow the water to run into
the washbasin.
You can choose between two different jet functions by sliding
9
the jet switch down or up (before doing so, turn off the water
m
stream by sliding the handle switch down):
Rotating stream for general cleaning and gum massage
(jet switch in lower position): The rotation of the water stream
and its micro-bubbles is designed for easy penetration below
the gumline.
Mono stream: straight water stream for site-specific cleaning
(jet switch in upper position)
Max. operating time: 15 minutes
Cooling off time: 2 hours
To ensure the jet functions, a small sieve is incorporated in the
lower end of the shaft. Should you notice a reduced water
pressure, check the sieve for any deposits and remove them,
e.g. by carefully tapping the shaft on a flat surface.
8