Fellowes POWERSHRED P-12C Guia De Inicio Rapido página 3

BASIC SHREDDING OPERATION
Continuous operation:
Up to 5 minute maximum
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 5-minutes will trigger
20-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE ®
TECHNOLOGY OPERATION
Stops shredding immediately when
hands touch the paper opening.
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a machine
may experience diminished sheet capacity, intrusive noise when shredding and
could ultimately stop running. To avoid these problems, we recommend you oil
your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off (O) * Apply oil
across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
PAPER JAM
1 2
Set to Reverse Alternate slowly back and forth
(R) for 2-3 seconds
PAPER/CARD
1
2
Plug in and put
Set to Auto-On (I)
disconnect power
switch in ON (I) position
SET-UP AND TESTING
1
Set to Auto-On (I)
3
Set to Reverse (R)
2-3 seconds
3 4
Set to Off (O)
and unplug
3
Feed paper/card
straight into paper
entry and release
2 3
Touch test area and SafeSense
look for the SafeSense working properly
®
indicator to illuminate
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
Turn OFF (O) and Locate Auto-start
unplug shredder infrared sensor
indicator will illuminate and the shredder will stop shredding.
®
5 6
Set to Auto-On (I) and
Gently pull uncut
resume shredding
paper from paper
entry. Plug in.
4
When finished
shredding set to
OFF (O)
is active and
®
.
4
3
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
3