Operating Instructions - Lexus PA Manual Del Usuario

GB
1. Introduction
The vehicle is equipped with a system that facilitates
parking manoeuvres by detecting obstacles that
could damage the front bumper of the vehicle.
2
PA will be activated automatically after engine
starting and signalled by the switching ON of LED
in the operating switch
1
dashboard.
The detected obstacle will be indicated by an
intermittent acoustic signal, that increases in
frequency until it becomes a continuous signal as
the vehicle moves closer to the obstacle.
± 30 cm
± 60 cm
Bip
AOM 001 564-0
06DE3904A.indd 6
Static zone: PA detects obstacles in the external
protection zone and emits an intermittent acoustic
signal, even when the vehicle is at a standstill. The
frequency of the signal increases with the proximity
of the obstacle to the bumper.
1
3
Continuous signalling zone: this is the zone nearer
to the bumper. PA detects obstacles and emits a
continuous acoustic signal, whether the vehicle is at a
located near the
3
standstill or moving. If the obstacle is too close to the
bumper, the system may not emit an acoustic signal.
The LED logo
is switched-ON.

2. Operating instructions

• Switch ON the engine.
• LED
• Now PA is ready to detect front obstacles.
• PA detects front obstacles up to a maximum vehicle
• To switch OFF PA, press the switch
• To switch ON PA press the switch
Bip Bip
6/56
Biiiiiii............p
2
is illuminated when the ignition
1
will turn on, to signal correct PA
functionality.
speed of approximately 20 Km/h and it will be re-
enabled if the vehicle speed will be reduced below
approximately 15 Km/h.
will switch OFF.
1
1
The LED will switch ON.
3
, then LED
3
.
23/09/2013 14:36:09