ClearSounds Talk500 V508 Manual Del Usario página 12

initial letter of the name of the person you wish to call using the
number pad. After a short time, the display will show the first
stored telephone number with this initial letter, say the name
and VoICE icon is shown if it was recorded, or voice the telephone
number. You can now search for further numbers under this letter
by pressing
• If no telephone number is stored, the display will show EMPTY.
• After you view all the calls in memory, the display will show END
oF LIST.
To Dial A Number From The phonebook
1. With the required telephone number showing on the display (step
above), press DIAL button. The telephone dials out the displayed
telephone number automatically in speakerphone mode.
2. The display shows dialed out telephone number and counting
timer.
1. pick up the handset or press
and wait for a dial tone.
2. press and release
3. Review the stored phone number by pressing
4. press DIAL button.
Recording / Editing / Deleting Voice prompt of Name
With Caller ID service activated, when an incoming call is received,
the unit will display and announce the caller's phone number. If the
caller's phone number is stored in the phonebook, caller's name will
be displayed too.
If the voice prompt is recorded for this phone number, the unit will
announce the voice prompt recorded instead of the caller's phone
number.
1. press and release the MENU button until the "NAME RECoRDING" is shown.
2. press the DIAL button. A list of the phone book entries will be display.
3. press or
4. To record or edit the voice, hold down DIAL button. Speak clearly
into the microphone after a beep and "VoICE" icon flashing.
.
please Note:
button, until
of phonebook
to select the list you like to record a voice or name for it.
-oR-
button (the speaker LED will light)
icon is shown.
12 – ENGLISH
or .