Positioning The Fabric And Sewing - Baby Lock Symphony BLSY Manual Del Usario

o
Lightly hold the end of the upper thread while
turning the handwheel toward you
(counterclockwise) until the mark on the
handwheel aligns with the line on the
machine.
p
Gently pull the upper thread to pull up the
bobbin thread through the needle plate.
→ A loop of the bobbin thread comes out through the
hole in the needle plate.
q
Use the presser foot lever to raise the presser
foot.
r
Insert tweezers through bobbin thread loop
and pull bobbin thread above the needle
plate.
s
Align the upper thread and bobbin thread,
and then pull out about 10 cm (approx.
4 inches) of the threads and pass them under
the presser foot toward the rear of the
machine.
12
t
Install the the cord guide bobbin cover (for
bobbin work and attaching cords).
a
Cord guide bobbin cover (for bobbin work and
attaching cords)
u
Press or
screen.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.

Positioning the Fabric and Sewing

Note
• Recommended stitches for bobbin work are open
"airy" type stitches.
• Be sure to sew trial stitches using same fabric and
threads as project in order to check the sewing results.
• The bobbin thread may become tangled due to the
type of pattern and thread that are being used. Since
this may cause the needle to break, immediately
stop sewing if this occurs. Turn off the machine, and
then cut out the tangled thread with scissors. Then,
clean the race and bobbin case as described in
"Preparing the Bobbin Thread" on page 9.
a
Select a stitch. For this example, press
Memo
• For best results, select a longer stitch length and a
wider stitch width. Depending on the selected stitch,
it may not be possible to change the stitch length
and stitch width.
• Depending on the fabric, bunched stitches may
result. We recommend selecting a simple stitch and
sewing trial stitches to check the sewing results.
Examples of simple stitches:
on the
.
, ,