Publicidad
Idiomas disponibles
Idiomas disponibles
BML-M31-I_0-A0-M075/060-R_
Reference Body – Magnetic Ring
Dimensions
Optical reference point marking
BML-M31-I_0-A0-M075/060-R_ dimensions
User's guide download
A complete user's guide can be downloaded from the
Internet at www.balluff.com/downloads-bml or
requested via e-mail from service@balluff.de.
Installation
Longitudinal installation/travel direction
Tangential offset
Transverse direction of installation/travel
Tangential offset
Distances between the sensor head and reference body
www.balluff.com
The magnetic rings can be used with the following sensor
heads:
Note: The sensor head for the BML-...-R1 magnetic ring
must be equipped with a reference point sensor. Sensor
heads BML-S1A, BML-S1B, BML-S1C, BML-S1E may not
be used.
Transverse offset
Transverse offset
Technical data
BML-M31-I30-...
Pole width
1 mm
No. of poles
238
Material
Stainless steel with elastomer coating
BML-...-R0
With reference
No
point
Suitable sensor heads
BML-M31-I30-...
Sensor head
1 mm system
examples
BML-S_A...-M3...
BML-S_F...-M3...
The following distances and tolerances must be strictly
observed when installing the sensor head and
magnetic ring.
The dimensions can be found in the respective user's
guide for the sensor head:
–
Gap between the sensor head and reference body
–
Transverse offset between the sensor head and
reference body
–
Tangential offset between the sensor head and
reference body
–
Permissible angular tolerances
–
Position of the reference point sensor/incremental
sensor
–
Area in which no magnetizable material may be
used
Legend:
1 Incremental sensor
2 Area without magnetizable material
3 Reference point sensor
4 Reference point marking
BML-M31-I40-...
5 mm
48
BML-...-R1
Yes
BML-M31-I40-...
5 mm system
BML-S_B...-M4...
BML-S_C...-M4...
BML-S_E...-M4...
english
1
Publicidad
