tau K205M Guía Para La Instalación página 17

7 on: set for CITY/V and RBL4;
off: set for CITY/M;
8 on: the memorization function is enabled for self-learning of the travel;
off: leave the dip-switch in this position when the memorization procedure has been
completed.
Clock function:
A timer connected to the input of the open-close button can be used to keep the bar open during
particular times of the day and also permits the automatic closure.
TCA
- + -
LED - DL3
The LED, besides indicating that the power supply is connected, also signals errors with a series
of pre-defined flashes:
• steady light:
• 1 flash:
Check the mains power supply, charge the battery, replace the battery;
• 2 flashes:
Disable phototest (dip-switch 6 OFF), check operation and connection of photocells;
• 3 flashes:
Check the thermal-magnetic circuit breaker (upstream from system), check the fuses;
• 4 flashes:
Excessive absorption peaks of the gearmotor, check that there are no obstacles throughout
the movement of the bar, check the motor's absorption of current when loadless and applied
to the bar;
• 5 flashes:
Check wiring, check encoder through TEST-ENCODER (optional)
• 6 flashes:
Check that there are no obstacles throughout the movement of the bar and the balance of
the bar;
• 7 flashes:
Execute memorization procedure.
• 8 flashes:
Reset manoeuvre counter
N.B.: The microprocessor version installed in your control panel is not enabled for
manoeuvre counting.
RALL
+ - +
normal operation;
buffer battery voltage lower than 11.3 Vdc;
phototest error;
power failure;
max current limit exceeded;
absence of encoder signal;
presence of obstacle after 5 failed attempts to close;
no memorization procedure has been executed;
max no. of programmed manoeuvres has been exceeded (optional).
FR
TCA
- + -
ON
1 2 3 4 5 6
K205M
CN1
RALL FR
+ - +
7 8
K205M CHARACTERISTICS
Dip-switches
17