Faber HILTIS36WHNB Instrucciones De Instalación Información De Uso Y Cuidado página 30

Installing the Battery
• The remote control is powered by a CR2032 type 3 V battery (not included).
• Remove the screw and install the battery.
• Check that the battery is installed with the " + " side up.
Caution:
• Do not place the remote control near heat sources.
• Do not discard the batteries with normal waste, they must
be put into the specific containers.
• Make sure the battery compartment is screwed down flat
and is fully tightened..
Motor On/Off.
-
-
Lights On / Off.
Press for 2 seconds to Activate Dimmer.
Activates/Deactivates Intensive operation
Brief pressure: Activates/Deactivates the Delay function: automatic switch-off with a 30' delay. The
display shows the operating speed and the dot at the bottom right flashes once a second.
Increases the working speed each time it is pressed
Decreases the working speed each time it is pressed
Attention: This hood has been engineered to minimize electromagnetic interference (EMI) originating
from the consumer's home power source. However, in some home application, ambient EMI and
excessive EMI from other electronic sources can compromise the reliability of the remote control.
Please speak with your Faber Distributor about an optional spare part to further reduce EMI from home
sources.
30
Remote control information
Remote Control control panel