Fan Assembly. Pgs - Craftmade Ellington E-BFT52ABZ5C Guia De Instalacion

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once you
are set on the ladder.
Continue to "Wiring" section for wiring diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal 6
holes. Notice that 3 of these holes are larger than
the rest of them.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy with
the 3 existing screws in top of motor housing.
Insert the 3 screws and 3 lock washers that were
removed (if there were only 3 screws located in
top of motor housing, these screws/lock washers
will be located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the non-slotted
holes on the rim of the canopy to do so.)
Continue to "Wiring" section for wiring diagram.
canopy
page 5
hanging bracket tab
hanging ball slot
canopy
canopy cover
canopy
motor housing
hanging bracket tab
motor housing
yoke