Testing Your Fan - Craftmade Ellington E-BFT52ABZ5C Guia De Instalacion

10. Light Kit Assembly (Optional). (cont.)
Connect WHITE wire from switch housing to WHITE
wire from light kit fitter. Connect BLACK (or BLUE)
wire from switch housing to BLACK wire from light kit
fitter. Be sure that molex connections snap together
completely.
Align holes in light kit fitter with holes in switch
housing. (Note: The gap on the top edge of the switch
housing cap must align with the reverse switch on the
switch housing for proper fit.) Attach light kit fitter
with 3 screws and star washers that were previously
removed. Secure all 3 screws securely with Phillips
screwdriver.
Attach 4 glass shades using thumbscrews provided in
one of the hardware packs. Do NOT overtighten
thumbscrews as glass may crack or break.
Install 4 candelabra base 40 watt max. bulbs
(included).
Important: When replacing bulbs, please allow bulb(s)
and glass shade(s) to cool down before touching
them.

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain
on switch housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the OFF
setting. Test lights with pull chain in the middle of the
light kit fitter. If fan and/or lights does/do not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 3), fan will not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to the ends of the
pull chain.
switch
housing
white wire
pull chain
extension
white wire
thumb-
screws
bulb
diagram 1
page 8
motor housing
reverse switch
black (or blue) wire
molex connector
black wire
thumb-
screw
glass
shade
pull chain
extension
diagram 2
diagram 3
light
kit
fitter