Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade Ellington E-BFT52ABZ5C Guia De Instalacion

9. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat with
remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
10. Light Kit Assembly (Optional).
If you wish to use your fan WITHOUT the light kit,
leave fan as configured from factory--with the
switch housing cap attached to switch housing.
Please proceed to Section 11 on the following page
to complete installation without the light kit.
If you wish to use your fan WITH the light kit,
remove 3 screws and star washers from switch
housing. Remove switch housing cap. Punch
center cap out of switch housing cap with a
screwdriver.
Locate BLACK (or BLUE) and WHITE wires in
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove wire connectors from these same wires as
well--save wire connectors for later use.
Remove hex nut and lock washer from threaded
rod on light kit fitter. Push wires from light kit
fitter through hole in middle of switch housing
cap and screw switch housing cap onto threaded
rod followed by the lock washer and hex nut.
Tighten hex nut over lock washer for a secure fit.
["Light Kit Assembly" continued on next page.]
*
plastic
motor
lock
lock
washers
white wire
molex connectors
center cap
hex nut
lock washer
page 7
blade screw and washer
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
motor housing
switch housing
black (or blue) wire
switch housing cap
switch housing cap
light kit fitter
blade