S&P PIV-W Manual Del Usuario página 19

ASSEMBLY:
Pine tree
Back panel
Space
Pine tree
Pine tree
Pine tree
Figure 5: Panel / housing
7 Fit the internal front panel by aligning the eight rivet holes. Attach the front panel to the
central housing by snapping the rivets into place. To do so, put the body of the rivet into the
housing and fix the front panel in place with the head of the rivet. Make sure the filter is
properly in place.
8 Connect the white tube to the power source (3 cables). An incorporated 3-Amp fuse box is
provided.
9 Connect the battery cable (2 wires) to the switch provided.
10 Attach the external front facing panel on the lower front edge.
3 Remove the adhesive security tape for transport from
the back panel (figure 1). Introduce the back panel into
the central housing (figure 2) making sure the filter guides
fit together correctly.
4 Attach the back panel to the central housing with the 4
pine trees provided. Figure 5 shows an example of a unit
installed on the right. For left-side installation, do it on the
other side.
5 Put the plug provided into the space in the front panel of
the central housing.
6 Fit the device onto the duct (including the side panel for
side air supply). Make sure the cable runs out of the
space provided in the side panel. Mount the unit using the
5 points on the back panel.
19