Publicidad
Idiomas disponibles
Idiomas disponibles
Bagger Mount
Full Rear Guard
1. Find the mount tube (A), lower mount hitch
(B) and upper mount hitch (C) from the kit.
Attach the upper and lower mounts to the
mount tube with four 5/16-16 x 1-3/4 round
head shoulder bolts and nuts. Be sure the
elbowed arm of the tube is on the right side
with the mount hitches installed to the front.
A
FRONT
2. Attach the tube assembly to the machine at
the upper hitch mount with two 5/16-18 x 3/4
round head shoulder bolts and nuts. Use the
outer left hole and the inner right.
D
3. Install the mount straps (D), bends to the
inside, on the outside of the mount tube
using 5/16-18 x 2 hex bolts and nuts.
4. Attach the front end of the mount straps to
the fuel tank brackets with 3/8-16 x 1 round
head shoulder bolts and nuts.
ASSEMBLY
C
B
D
5. Attach the lower mount hitch to the frame
with one 1/2-13 x 1 hex bolt and nut.
6. Tighten all hardware.
Semi Rear Guard
1. Find the mount tube (A), lower mount hitch
(B), spacer plate (E) and support bracket (F)
from the kit. Attach the mount hitch to the
mount tube with 5/16-18 x 1-3/4 round head
shoulder bolts and nuts. Be sure that the
elbowed arm of the tube is on the right side
with the mount hitch installed to the front.
2. Attach the support bracket to the tube
assembly with two 5/16-18 x 1-3/4 round
head shoulder bolts and nuts.
3. Attach the lower mount hitch to the frame.
with a 1/2-13 x 1 hex bolt and nut.
A
4. Install the mount straps (bends are to the
inside) on the outside of the mount tube
using 5/16-18 x 2 hex bolts and nuts.
5. Attach the front end of the mount straps to
the fuel tank brackets with 3/8-16 x 1 round
head shoulder bolts and nuts.
E
F
B
5
5
Publicidad
