Reattaching The Refrigerator Doors; Disassemble The Freezer Drawer - Samsung RFG296HD Manual De Usuario

1
2. Disconnect one connector ( 3 ) on the right side
door and one connector ( 4 ) on left side door. To
remove the water coupler from the hinge, twist and
pull it from the hinge. Remove the water line ( 5 )
while pressing the marked part ( 6 ) of the water line
coupler.
If a red clip is on the coupler, it must be
removed before removing the tube.
CAUTION
4
Red Clip Red Clip
(1/4") (1/4")
5
6
3. Pull and remove the hinge lever ( 7 ). Remove the
ground screw ( 8 ) attached to the upper left and
right door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges ( 9 ).
7
9
4. Lift the door straight up to remove.
5. Remove the screw ( 10 ) attached to the lower left
2
REATTACHING THE
REFRIGERATOR DOORS
To reattach the fridge doors after you have moved the
fridge to its fi nal location, assemble parts in reverse
order.
3
DISASSEMBLE THE FREEZER
DRAWER
1. Take out the upper drawer
2. Remove the tilting pocket
8
3. Take out the lower basket
4. Remove 4 hex head bolts
5. Lift up the freezer door from
and right door hinges with a philips screwdriver (+).
Remove the 2 hex head bolts ( 11 ) attached to
the lower left and right door hinges with an allen
wrench (3/16"). Remove the lower left and right
door hinges ( 12 ).
12
10
11
Allen wrench Allen wrench
by lifting it up.
( 1 ) by pulling both support
guards ( 2 ) upward at the
same time.
( 3 ) by lifting the basket up
from the rail system.
from both sides with a socket
wrench (10mm).
the rails.
1
2
Slot
3
setting up _07