Health O Meter Professional PROPLUS Instrucciones De Uso página 7

ASSEMBLY INSTRUCTIONS (CONTINUED)
8. Locate the display module assembly and remove the stand at the rear of the display
assembly by unscrewing 4 screws (see Figure 3 - A).
9. Insert the power cord into the adapter jack, marked ―POWER‖, on the back of the display.
10. Secure the power cord (B) in the channel located beneath the adapter jack on the display.
11. Reinstall the display stand on the back of the display and secure it with the 4 screws (A).
12. Connect the free end of the load cell cable to the load cell port on the inner side of the
right ramp.
13. Level the scale by adjusting the plastic feet.
14. After the first assembly, for scale folding and moving purposes, leave the eight plastic
feet, power cord and load cell cable connected to the display assembly for the next use.
Figure 3
7