Publicidad
Idiomas disponibles
Idiomas disponibles
Push 2 knobs.
Use projected line as reference.
CLAMP ACCESSORY H (figure 7).
For projecting lines on board materials (thickness 15 - 30
mm).
Slide tool on accessory H.
Fasten accessory H onto board by turning knob clockwise
Use projected line as reference.
PIN ACCESSORY J (figure 8).
For projecting lines on plasterboard, soft wood, and other
soft materials.
Slide tool on accessory J.
Place accessory J onto surface.
Level the tool (ensure that the bubble in the relevant level is
centered).
Push 2 knobs.
Use projected line as reference.
Be aware of the sharp pins.
MAGNET ACCESSORY K (figure 9)
For projecting lines on any ferrous metal surface or profile
Slide tool on accessory K.
Place accessory K onto surface.
Level the tool (ensure that the bubble in the relevant level is
centered).
Use projected line as reference.
SCREW ACCESSORY L (figure 10)
For projecting lines at the same level as already mounted
screw.
Place accessory L over already mounted screw.
Slide accessory L to the left/right, so that screw ends up
firmly in tapered end of peg.
Slide tool on accessory L.
Level the tool (ensure that the bubble in the relevant level is
centered).
Use projected line as reference for mounting other
screw(s).
Screw accessory L can also be used in combination with
tape or drawing-pins.
PIVOT ACCESSORY M (figure 11)
For projecting lines at an angle (for rough indication only).
Remove knob by turning it counter-clockwise.
Slide tool on magnet accessory K.
Fasten magnet accessory K on accessory M by turning
knob clockwise.
Move tool over graduated arc by loosening/fastening knob.
Pivot accessory M can also be used in combination with
tape or drawing-pins.
BELT CLIP ACCESSORY N (figure 12)
For easy and convenient storage.
Maintenance and cleaning
•
Do not expose the tool to continuous vibration or
extremely hot or cold temperatures
•
Always store the tool indoors in its protective carton/case.
•
Always keep the tool free of dust, moisture and direct
sunlight
•
Clean the tool with a damp cloth and mild soap
Always remove the batteries before cleaning the
lens.
•
Do not disassemble or modify the tool in any way
•
Do not attempt to change any part of the laser lens
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair should be
carried out by an authorized customer services center for
SKIL power tools.
Guarantee
We guarantee SKIL appliances in accordance with
statutory/country-specific regulations (proof of purchase by
invoice or delivery note).
Damage attributable to normal wear and tear, overload or
improper handling will be excluded from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the SKIL Service Center
for Electric Power Tools.
Warning!
Freight and insurance costs are charged to the client, even
for warranty claims.
Environmental protection
Recycle raw materials instead of disposing as waste.
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
No tirar los acumuladores/pilas agotados a la basura, al
fuego, o al agua Deseche la herramienta clasificando el
alojamiento y las pilas para reciclaje inocuo para el
medioambiente.
The plastic components are labeled for categorized
recycling.
Subject to change without notice
12
Publicidad
