OVE KELSEY Manual De Usario página 12

1. Drill a hole on the center marks with a ø5/16" (8mm) drill bit.
2. Insert the wall anchors (DD) using a rubber mallet. Fix the center fitting on the support bar's anchor (D) using the
screws (JJ).
Note: Before continuing, place the door panel (J) inside the shower enclosure to facilitate future steps!
3. Slide again the roller stoppers (E) and the support bar's anchor (D) onto the support bar (F). Then fix the support
bar to the wall and the side panel.
4. Fix the fixed panel (C) onto the support bar (F) using the brackets (G).
5. Secure the support bar (F) on their anchors using the provided hex screws. Install the aluminum profile (W)
between the roller stopper and support bar's anchors.
1
ø5/16"
8mm
3
D
E
5
W
D
E
SUPPORT BAR INSTALLATION
F
12
2
D
JJ
DD
4
G
C
F