Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the floor pads
-All pads and floor attachments are washable
-The brushes and scouring pads can be washed under
the tap with warm soapy water. The blue & yellow
polishing pads can also be machine washed in cool
water and dried naturally. It is recommended to
re-shape the pads whilst drying
-The polishing head unit is not suitable for washing
in water, it must be wiped with a damp cloth
Troubleshooting
Smear marks are made on floor when polishing
-Has the polish/wax been allowed to dry?
-Does an existing floor treatment need to be removed?
No gloss sheen is being produced
- Floor polish/wax application level may need to be
increased, try another coat. Allow to dry and re-polish.
- Please note some types of floor do not produce
gloss finish.
Scratches are made on the floor
- Check for grit or dirt stuck to the pads or on the
rear wheels
- Clean/replace the pads or wipe the wheels free
from debris
Floor is too slippery
- Check the polish/wax is designed to be used on
floors. Good floor polish should always produce a
glossy but grippy finish
Vacuuming
You may use the vacuum while polishing on hard
floors only. Alternatively use the EPV1100 as a
standalone vacuum by changing to the vacuum
head and use on hard floors throughout the home.
Additional Accessories
A pack of accessories for the EPV1100 is also available to enhance your experiences with the unit
and can be purchased by contacting us using the contact information found within the manual.
Assembling the Vacuum
Floor vacuum / upright vacuum mode
-Leave the metal extension handle in place
if the EPV1100 is to be used as a floor or
upright vacuum
-Remove the polisher head by depressing
the button at the back of the polisher head
and lifting the vacuum body clear (Fig. 11)
-Please note that the parts do not click
together
-The unit is now suitable for use as a floor /
upright vacuum (Fig. 12)
Fig. 11
Fig. 12
6
Publicidad
