Rear Connections - Numark 200FX MKII Manual De Inicio Rápido Para El Usuario

1. Make sure all items listed on the front of
this guide are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET
BEFORE USING THE PRODUCT.
3. Study this setup diagram.
4. Place mixer in an appropriate position for
operation.
5. Make sure all devices are turned off and all
faders and gain knobs are set to "zero"
6. Connect all stereo input sources as
indicated in the diagram.
7. Connect the stereo outputs to power
amplifier(s), tape decks, and/or other audio
sources.
8. Plug all devices into AC power.
12
10
11
1. Phono Inputs: This input is used for
connecting your turntables through the
sensitive RIAA phono preamplifiers. Only
turntables with phono level output should be
attached. Line level turntables must be
attached to the line inputs.
2. GND: This screw connector should be used
to secure any turntables or other devices
connected to the mixer that need to be
grounded.
3. Line Inputs: CD players, Tape Decks,
Samplers or other line level input devices
should be connected to these inputs.
4. Microphone Input: Microphones with a ¼"
connector can be connected to these input
terminals.
5. Fader Start Connector: to attach your
mixer to a remote start equipped Numark CD
player using industry standard 1/8"(3.5mm)
cables.
6. Zone Output (RCA): This output is for
connecting an external monitoring device
such as a PA system, powered monitors or a
home stereo. The level of the zone stereo
output signal is controlled by the zone fader.
MIXER QUICK SETUP
5
9 9 8 7 6

REAR CONNECTIONS

9. Switch everything on in the following order.
• audio input sources (i.e. turntables or
CD players)
• mixer
• last, any amplifiers or output devices
10. When turning off, always reverse this
operation by,
• turning off amplifiers
• mixer
• last, any input devices
11. Go to http://www.numark.com
registration.
More information about this product may be
found at http://www.numark.com
2
3 3 3 1
7. Record Output: This RCA output is for
connecting a recording device such as a tape
deck or CD recorder. The level of the record
output is based upon pre-master levels.
8. Master Output (RCA): This output is for
connecting an external monitoring device
such as a PA system, powered monitors or a
home stereo. The level fo the master stereo
out put signal is controlled by the master
fader.
9. Stereo Balanced Master Outputs (XLR):
low-impedance XLR type connectors
controlled by the Master fader.
10. AC In: This mixer is designed to work with
the power supply cord that comes with the
unit. While the power is switched off, plug
the power supply into the mixer first, then
plug it into the outlet.
11. Voltage Selector: Set this to the correct
voltage for your location standard.
12. Power Switch: Use this switch to turn on
the mixer after all input devices are already
connected to prevent damage to your
equipment. Turn the mixer on before you
turn on amplifiers and turn of amplifiers
before you turn off the mixer.
for product
2 2
4
3 1 3 1
4
4
4