Ns7; Rear Panel Overview; Front Panel Overview - Numark NS7 Manual De Referencia

NS7

REAR PANEL OVERVIEW

1
1. USB – This USB connection sends and receives audio and control information from a connected computer.
2. MASTER OUTPUT (BALANCED) – Connect this low-impedance XLR output to a PA system or powered monitors. The level of
this output is controlled with the MASTER knob on the top panel.
3. MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system. The level of this
output is controlled by the MASTER knob on the top panel.
4. BOOTH OUTPUT (RCA) – Use standard RCA cables to connect this output to a booth monitoring system. The level of this output
is controlled by the BOOTH knob on the top panel.
5. POWER IN – Use the included power cable to connect NS7 to a power outlet. While the power is switched off, plug the cable into
NS7 first, then plug the cable into a power outlet.
6. POWER SWITCH – Turns NS7 on and off. Turn on NS7 after all input devices have been connected and before you turn on
amplifiers. Turn off amplifiers before you turn off NS7.

FRONT PANEL OVERVIEW

2
1
1. MIC INPUT – Connect a 1/4" microphone to this input.
2. AUX INPUT (RCA) – Use standard RCA cables to connect a line-level device, such as a CD player, sampler or audio interface, to
this input.
3. MIC / AUX SWITCH – Activates or deactivates the MIC INPUT and AUX INPUT. For best signal-to-noise performance, turn this
switch off when not in use.
4. MIC / AUX GAIN – Adjusts the pre-fader, pre-EQ audio level of the MIC INPUT and AUX INPUT.
5. MIC / AUX BASS – Adjusts the low (bass) frequencies of the MIC INPUT and AUX INPUT.
6. MIC / AUX TREBLE – Adjusts the high (treble) frequencies of the MIC INPUT and AUX INPUT.
7. FADER START – Enables or disables Fader Start on the corresponding side of the crossfader. When Fader Start is enabled on
one side, moving the CROSSFADER toward that side will cause that channel to start playing. Moving the CROSSFADER away
from that side will cause that channel to stop, and the audio will return to the beginning of the track.
8. MOTOR TORQUE – Flip this switch to adjust the torque of the PLATTERS. At the high setting, the PLATTERS will have the
heavier, stronger feel of "modern" turntables. At the lower setting, they are lighter and more graceful – the feel of a "classic"
turntable.
9. CROSSFADER (XFADER) CONTOUR – Adjusts the slope of the crossfader curve. Turn the knob to the left for a smooth fade
(mixing) or to the right for a sharp cut (scratching).
10. CROSSFADER (XFADER) REVERSE – Reverses the assignment of Channels 1 and 2 on the CROSSFADER. (An LED on the
top panel labeled "XFADER REVERSE" will illuminate when activated.)
11. HEADPHONES – Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.
12. HEADPHONE VOLUME – Adjusts the level of the headphone audio.
All manuals and user guides at all-guides.com
2
4
3
4 6
3 5
8 10
7 9 7
3
6
5
12
11