Rear Panel - Numark MIXTRACK II Guia Del Usuario

REAR PANEL

1. USB – Sends USB MIDI data to control various software parameters.
BEATMIXING WITH MIXTRACK II AND VIRTUALDJ LE
Below is an example of how to mix tracks using Mixtrack II and VirtualDJ LE:
1. Load tracks onto Decks 1 and 2 of VirtualDJ LE by using the Load A and
Load B buttons on Mixtrack II.
2. Move the crossfader all the way to the left on Mixtrack II.
3. Turn the Cue Mix knob all the way to the right to 'PGM'.
4. Play the track that is loaded on Deck 1.
5. Play the track that is loaded on Deck 2 and match it's BPM to Deck 1's track. To match the
BPM, press Deck 2's Sync button on Mixtrack II.
6. Once the BPM is matched, move the crossfader on Mixtrack II to fade between Deck 1
to Deck 2.
BEATMIXING TRACKS IN OTHER PROGRAMS
If you are using Mixtrack II with another software program that does not support BPM syncing between
decks, follow the traditional example below to sync tracks. You can match the tempo by ear and adjust
the pitch by monitoring the music from both decks in your software.
1. Play the track on Deck 1.
2. Play the track on Deck 2.
3. Listen to Deck 2 in your headphones. If the beat of Deck 2 is faster than Deck 1, move the
pitch fader to the ( - ) side. (see Figure 1.)
4. If the beat of Deck 2 is slower than the beat of Deck 1, move the pitch fader to the ( + ) side.
(see Figure 2.)
Note: This procedure can be done on either Deck.
6
1
Figure 1
Figure 2