Warnings; Assembling The Exersaucer - Evenflo ExerSaucer Manual De Instrucciones

Assembling the ExerSaucer

2. Locate (3) feet
Remove foot by squeezing tab
A
D
3. Align slots in foot
Repeat until all three (3) feet are installed on legs. Pull foot to
make sure it is locked onto leg.
D
F
H
G
B
on underside of tray .
as shown.
D
with tabs on leg . Snap foot onto leg.
B
4. Place seat ring upside down and locate the wheel
holders . Snap six (6) seat wheels
holders, as shown.
12
E
F
F
into wheel
N
5. Turn seat ring right side up.
Align triangles
triangles on the seat pad label.
J
Snap the plastic tabs
seat ring.
K
Continue this process until all tabs are attached to
all pegs, then push the seat pad down inside the seat ring.
I
L
M
6. Press assembled seat ring
the tray until it snaps into place and spins freely.
A
To adjust height:
ALWAYS remove baby from ExerSaucer before adjusting.
Push button
sure that all three legs are adjusted to the same position.
To avoid injury, allow the baby's toes only to touch the floor.
DO NOT allow the baby to stand flat-footed on the floor.
As baby grows and becomes more active, raise the tray to
N
the next level so that baby enjoys the most comfortable fit
and maximum use of the spin, and bounce features.
13
Assembling the ExerSaucer
on the back of the seat ring with the
on the pad over the pegs on the
down firmly onto the top of
until the desired position is obtained. Make
WARNING