Technical Service; Regulatory Information - Heath Zenith 6180 Serie Manual Del Usuario

Chime does not sound:
• Make sure push button and chime codes are the same (See pages 3 and 4).
• Check orientation of push button battery (See page 4).
• Check charge of push button and chime batteries, replace if necessary.
Batteries seem OK, but the chime does not work when installed:
• Do not mount chime or push button on metal or near metal studs. This
reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to
move chime or push button off metal surface.
• Concrete floors may reduce range. Move chime away from floor.
• Try locating chime closer to push button.
The range of the wireless chime can vary with location, temperature and bat-
tery condition.
If you experience a problem, follow this guide. You may also want to visit our
Web site at: www.desatech.com. If the problem persists, call* for assistance at
1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products™
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available:
Model Number, Date of Purchase, and Place of Purchase.
This device (SL-6180-RX-A, WB-94A-TX, or WB-97-TX) complies with Part 15
of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
The term "IC:" before the radio certification number only signifies that Industry Canada
technical specifications were met.
The user is cautioned that changes or modifications not expressly approved by
the party responsible for regulatory compliance could void the user's authority
to operate the equipment.
595-5506-10
Troubleshooting

Technical Service

(Do Not Send Products)
No Service Parts Available for this Product

Regulatory Information

-5-