Automatic Fluid Refill Kit - Craftsman professional 14005 Manual Del Operador

automatic fluiD refill Kit

Included in the pump kit are components designed
to automatically maintain a constant level of new
fluid in the master cylinder or hydraulic clutch
reservoir while vacuum bleeding. The components
include two cap adapters that fit most pint and
quart brake fluid bottles (1-1/4" side mouth), and
three master cylinder/reservoir refill plates.
SERVICE PROCEDURES
1) Evacuate as much old fluid as possible from the
master cylinder or clutch reservoir.
2) Replace the lid on a pint or quart size bottle of
new brake fluid with the appropriate cap adapter.
3) Select the appropriate refill plate and place it on
top of the master cylinder or clutch reservoir.
4) Invert the bottle of fluid with the feeder adapter
attached, and insert the feeder adapter into the
hole in the master cylinder plate. Push down on the
bottle until the feeder adapter snaps into the refill
plate.
5) Bleed the hydraulic brake or clutch system.
NOTE: Take care when inserting and removing the
brake fluid bottle to avoid spillage.
FIGURE 17: AUTOMATIC FLUID REFILL KIT
20