Kohler K-2822 Manual Del Usuario página 5

Construct the Supports (cont.)
Measure and cut the 3/4" plywood to 36" (91.4 cm) (H) and rip to
the length of the 2x10, ensuring the plywood will sit flush with
the existing studs. Temporarily fit the plywood over the 2x10.
Measure, level, and draw a pencil line across the plywood with a
pencil at a height of 30-3/4" (78.1 cm) from the finished floor.
Mark two bolt hole locations 7-7/16" (18.9 cm) apart on the pencil
line.
Use a 1/2" drill to carefully drill through the plywood and 2x10
at the marked bolt hole locations.
Remove the plywood and 2x10 from the support studs
Fit the threaded inserts into the bolt holes in the 2x10 from the
front. Assemble the fender washers to the bolts, and thread the
bolts into the threaded inserts from the back. Securely wrench
tighten the bolts to the threaded inserts.
Fit the 2x10 assembly into the notches in the support studs so the
bolt shanks face outward. Use minimum 2-1/2" (6.4 cm) wood
screws (not provided) to secure the 2x10 to the support studs. Use
four wood screws in each end, and space the screws no more
than 2-1/2" (6.4 cm) apart.
Use wood screws (not provided) of sufficient size and quantity to
securely fasten the plywood to the support studs, ensuring that
the bolt shanks pass through the holes in the plywood.
Install the water supply and drain lines.
Install the wallboard and finished wall materials according to the
established installation procedures.
Kohler Co. 5 1018372-2-B