Fermax VEO DUOX Manual De Instalador página 25

DUOX X X X X VEO DUO DUO VEO VEO
DUO DUO VEO VEO
DUO DUO DUOX X X X X VEO DUO DUO VEO VEO VEO VEO
The selected option is displayed with the white line under the icon. Press ü, and you hear a
beep on the monitor.
The monitor will automatically connect with the entry panel, activating the camera. Enter the
calling code for this monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time between steps 4 and 5 must be less than 2 and half minutes.
- Programming is always done from the panel activated as the master panel.
2222
F1
A different call tone is produced, confirming the monitor's programming and the camera's image
is still viewed. After a few seconds the monitor returns to standby.
Option 2: From the Monitor Monitors can be programmed on the screen menu.
Program the call number: Press ü
the residence's number (numbers from right to left).
Each time the + is pressed the number increases (starting with 1) and the arrow is used for
moving the cursor. A white cursor indicates where the digit will be entered. Program the
corresponding number and accept with ü.
on the previous screen and access the screen to program
0 0 0 0 0 1
Page 9