Waeco Sine Power SP162 Instrucciones De Uso página 19

SP160_SP350.book Seite 19 Donnerstag, 22. Februar 2007 1:51 13
All manuals and user guides at all-guides.com
SinePower
Use the device only as intended.
Do not operate the device in a damp or wet environment.
Maintenance and repair work may only be carried out by qualified person-
nel who are familiar with the risks involved and the relevant regulations.
2.2 Safety when installing the device
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
Take the precautions necessary to ensure that children cannot interfere
with operation.
Dangerous situations may occur which cannot be recognised by chil-
dren!
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
Electrical cables
If cables have to be fed through metal walls or other walls with sharp edg-
es, use ducts or wire bushings to prevent damage.
Do not lay cables which are loose or bent next to electrically conductive
material (metal).
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in the same
duct.
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
General safety instructions
19