ASSEMBLY INSTRUCTIONS
1. Remove the two mounting brackets attached to
the back of the left and right front panels on mantel
(A) by removing the two screws on each mounting
bracket. Set aside.
PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO INSTALLING
INSERT (D) INTO THE MANTEL (A). INSTALL THE
INSERT (D) INTO THE MANTEL (A) CLOSE TO ITS
FINAL POSITION.
Lift insert (D) carefully into the back of the mantel
(A) and center the insert (D) in the opening. Do not
drag insert (D) as it may scratch the unit. Re-install
the previously removed mounting brackets to hold
the insert (D) fl ush against the inside of the front
panels of mantel (A).
Note: Move the completed unit only short distances
and with great care. It takes two people to move
completed unit into its fi nal position.
OPTIONAL CORNER EXTENSION
WARNING: Two people are recommended to
perform steps 2 and 3.
2. Set "L" corner brace (C) and top corner extension (B)
face down on a scratch-free surface. Insert one
wood dowel (CC) into each of the pre-drilled holes
on top corner extension (B). Attach the "L" corner
brace (C) to top corner extension (B), securing with
bolt (AA) and washer (BB)
HAND TIGHTEN ONLY.
Hardware Used
Bolt
AA
Washer
BB
CC
Wood Dowel
1
Mounting
Bracket
Completed
Unit
2
x 1
x 1
x 2
8
A
A
D
AA
C
BB
CC
B
Lowes.com
D