Maxon M-14-30 Manual De Instrucciones página 10

Before drilling holes in the pickup bed, ensure there are no obstructions or
items that could be damaged.
5. Hold RH mounting bracket against cor-
ner post of the pickup bed (FIG. 10-1).
Then, use 2 of the 4 bracket holes that
are not obstructed, to drill 2 holes for
3/8"-16 bolts in fl oor of the pickup bed
(FIG. 10-1). Repeat for LH mounting
bracket.
6. Bolt RH mounting bracket to the fl oor
of pickup bed as shown in FIG. 10-1.
Repeat for LH mounting bracket.
7. Unlatch and unfold platform. Refer
to C2 Operation Manual if needed.
Then, adjust liftgate position so plat-
form is level from front to back.
8. Securely tighten 3 bolts fastening
RH mounting bracket to main frame
bracket (FIG. 10-1). Ensure the split
lock washers are not in the slotted
holes on main frame bracket. Repeat
for LH mounting bracket.
CAUTION
1500 lb capacity liftgates require
additional support for the mount-
ing brackets. Bolt bracket to pickup
bed as shown in the illustration.
9. Use upper 3/8" hole in the RH mounting
plate as a template to drill hole through
RH corner post of pickup bed (FIG. 10-2).
Then, bolt RH mounting plate to corner
post as shown in FIG. 10-2. Repeat for LH
mounting plate.
10. If liftgate is C2-15 model (1500 lb ca-
pacity), go back and fi nish the steps for
changing the mounting of taillight lenses.
LIFT CORPORATION Sht. 10 of 38 DSG#
INSTALLING LIFTGATE - Continued
CAUTION
M-14-30
3/8"-16 HEX BOLT
(2 PLACES)
TEMPLATE HOLES
TO DRILL 2 HOLES
IN PICKUP BED
3/8" FLAT WASHER
(2 PLACES)
3/8" LOCK WASHER
(2 PLACES)
3/8" HEX NUT
(2 PLACES)
BOLTING RH MOUNTING BRACKET
TO PICKUP BED (LIFTGATE NOT SHOWN)
1500 LB CAP.
LIFTGATE ONLY
3/8"-16 HEX BOLT
3/8" FLAT WASHER
3/8" LOCK WASHER
3/8" HEX NUT
RH MOUNTING
BRACKET
FASTENING BRACKET TO INNER BOX
(RIGHT SIDE SHOWN)
Rev. C Date: 12/12/17
CORNER
POST
FLOOR OF
PICKUP BED
FIG. 10-1
CORNER
POST
:
FIG. 10-2