Maxon M-14-30 Manual De Instrucciones página 16

CAUTION
Hydraulic system is fi lled at the
factory with correct amount of oil.
It is unnecessary to add more oil
except as required for periodic
maintenance of the liftgate.
1. Remove the solid plug from the pump
reservoir (FIG. 16-1). Install breather
plug (Kit item) in pump reservoir.
2. Bolt on main frame cover (FIG. 16-2).
3. Install the two square plastic grommet
nuts (Kit item), for the license plate, into
the square holes on the Liftgate main
frame cover (FIG. 16-2).
4. Install the license plate using two
1/4"-20 self-tapping screws (Kit item)
(FIG. 16-2).
5. Install the license plate lights into the
holes provided. Refer to instruction sheet
M-14-35. Then, connect the license plate
lights to the vehicle's wiring.
LIFT CORPORATION Sht. 16 of 38 DSG#
COMPLETE LIFTGATE INSTALLATION
SELF-TAPPING SCREW
(2 PLACES)
M-14-30
BREATHER PLUG
RESERVOIR
INSTALLING VENT PLUG ON
PUMP RESERVOIR
FIG. 16-1
INSTALLING COVER & LICENSE PLATE
(C2 LIFTGATE SHOWN)
FIG. 16-2
Rev. C Date: 12/12/17
PUMP & MOTOR
5/16" HEX NUT,
5/16" FLAT WASHERS
(3 PLACES)
COVER
GROMMET NUT
(2 PLACES)
LICENSE PLATE
(REF)