Charger Location; Dc Connection Precautions; Follow These Steps When Battery Is Installed Invehicle - Schumacher Electric INC-812 Manual De Instrucciones Y Seguridad

3.3 Clean the battery terminals before charging the battery. During cleaning,
keep airborne corrosion from coming into contact with your eyes, nose
and mouth. Use baking soda and water to neutralize the battery acid and
help eliminate airborne corrosion. Do not touch your eyes, nose or mouth.
3.4 Add distilled water to each cell until the battery acid reaches the level
specified by the battery manufacturer. Do not overfill. For a battery without
removable cell caps, such as valve regulated lead-acid batteries, carefully
follow the manufacturer's recharging instructions.
3.5 Study all of the battery manufacturer's specific precautions while charging
and recommended rates of charge.
3.6 Determine the voltage of the battery by referring to the vehicle owner's
manual and make sure that the output voltage selector switch is set to the
correct voltage. If the charger has an adjustable charge rate, charge the
battery at the lowest rate first.
4.

CHARGER LOCATION

4.1 Locate the charger as far away from the battery as the DC cables permit.
4.2 Never place the charger directly above the battery being charged; gases
from the battery will corrode and damage the charger.
4.3 Never allow battery acid to drip onto the charger when reading the electro-
lyte specific gravity or filling the battery.
4.4 Do not operate the charger in a closed-in area or restrict the ventilation in
any way.
4.5 Do not set a battery on top of the charger.
5.

DC CONNECTION PRECAUTIONS

5.1 Connect and disconnect the DC output clips only after setting all of the
charger switches to the "off" position and removing the AC plug from the
electrical outlet. Never allow the clips to touch each other.
5.2 Attach the clips to the battery and chassis, as indicated in steps 6.5, 6.6,
and 7.2 thru 7.4.
6. FOLLOW THESE STEPS WHEN BATTERy IS INSTALLED IN
vEHICLE.
A SPARK NEAR THE BATTERy MAy CAUSE A BATTERy EXPLO-
SION. TO REDUCE THE RISK OF A SPARK NEAR THE BATTERy:
6.1 Position the AC and DC cables to reduce the risk of damage by the hood,
door, or moving engine parts.
6.2
Stay clear of fan blades, belts, pulleys and other parts that can cause
injury.
6.3 Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery
post usually has a larger diameter than the NEGATIVE (NEG, N, -) post.
3
• •