Leviton Lev-Lok Serie Instrucciones De Instalación

WARNINGS AND CAUTIONS:
• TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKER
OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING!
• TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE
ELECTRICAL CODES AND REGULATIONS.
• IF YOU ARE NOT SURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT
AN ELECTRICIAN.
TO INSTALL RECEPTACLE:
1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF
POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT
THE POWER IS OFF BEFORE WIRING!
2. Wire Module per Fig. 1.
3. Remove protective label from the Module to expose contacts (Fig. 2).
4. Connect Module to Receptacle.
a. Align rounded end of module with rounded guide on back
of receptacle and push module contacts onto receptacle pin
contacts (Fig. 3).
b. Turn module clockwise until it locks under receptacle tabs with
an audible "snap" (Fig. 4).
5. Wire Split-Circuit Hot Lead per Fig. 8.
NOTE: When the Control Symbol [
one outlet the black wire lead protruding from the back of the
device opposite the mark powers that outlet.
TO DISCONNECT RECEPTACLE FROM MODULE:
1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF
POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT
THE POWER IS OFF BEFORE WIRING!
2. Push receptacle tab #1 and turn module counterclockwise until
unlocked and separate (Fig. 5).
This product is covered by U.S. Patent Nos. 7,357,652; 7,666,010; 8,096,818;
7,355,117*; 7,820,909*; 8,242,362*, *applies only to Tamper-Resistant devices
Fig. 4
Split-Circuit
Hot Lead
Fil de sortie actif
du second circuit
Conductor Fase
del circuito dividido
Turn Module
Clockwise to Lock
Tourner le module vers la
droite pour le verrouiller
Gire el módulo hacia la
derecha para asegurar
FOR CANADA ONLY
For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton Manufacturing of Canada Ltd to the attention of the Quality Assurance Department, 165
Hymus Blvd, Pointe-Claire (Quebec), Canada H9R 1E9 or by telephone at 1 800 405-5320.
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper
use for ten years from the purchase date. Leviton's only obligation is to correct such defects by repair or replacement, at its option. For details visit www.leviton.com or call 1-800-824-3005. This warranty
excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused,
opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including
merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for
a particular purpose, is limited to ten years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment,
lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
© 2017 Leviton Mfg. Co., Inc.
Lev-Lok
] is marked on the face of
1
2
3
4
Fig. 5
Receptacle Tab #1
(push to release latch)
Taquet 1 de la prise
(pousser pour libérer le verrou)
Pestaña #1 del Receptáculo
(presione para soltar el seguro)
Receptacle Tab #2
Taquet 2 de la prise
Pestaña #2 del Receptáculo
LIMITED 10 YEAR WARRANTY AND EXCLUSIONS
For Technical Assistance Call: 1-800-824-3005 (U.S.A. Only) www.leviton.com
Split-Circuit
® Receptacles
WARNINGS AND CAUTIONS:
• MODULE CAN ONLY BE INSERTED ONE WAY ONTO RECEPTACLE. DO NOT
ATTEMPT TO FORCE IMPROPER ORIENTATION AS DAMAGE TO MODULE OR
RECEPTACLE MAY OCCUR.
• DO NOT USE RECEPTACLE OR MODULE IF TABS ARE BROKEN.
• USE THIS DEVICE WITH COPPER OR COPPER-CLAD WIRE ONLY.
INSTALLATION
Fig. 1
7
8
4
5
3
6
2
1
Switched Hot (Red) Module
5
Actif commuté (rouge) Module
Conmuta Fase (rojo) Módulo
Hot (Black)
6 Protective Label
Actif (noir)
Étiquette protectrice
Fase (negro)
Etiqueta protectora
Ground (Green) 7 Wire Connector
Terre (vert) Marette
(verde) a tierra Conector de alambre
Neutral (White) Electrical tape
8
Ruban isolant
Neutre (Blanc)
Neutro (Blanco) Cinta aislante
Fig. 6
Standard Module
Module standard
Módulo estándar
90 o Module
Module 90 o
Módulo de 90 o
Fig. 2
Module Contacts
Contacts du module
Contactos del módulo
Rounded
Guide
Guide
Guía
redondeada
Receptacle
Pin Contacts
Contacts de la prise
Contactos del pin
del receptáculo
Fig. 7
9
10
WARNING !
AVERTISSEMENT!
ADVERTENCIA!
INCORRECT ALIGNMENT
POSITION OF MODULE
MODULE MAL ORIENTÉ
POSICIÓN INCORRECTA DE
ALINEAMIENTO DEL MÓDULO
PK-A3126-10-02-0A
ENGLISH
Fig. 3
Split-Circuit
Hot Lead
Fil de sortie actif
du second circuit
Conductor Fase
del circuito dividido
Correct Alignment
Position of Module
Module bien orienté
Posición correcta de
alineamiento del módulo
Fig. 8
10
9
Split-Circuit Hot Lead
Fil de sortie actif du second circuit
Conductor Fase del circuito dividido
Lev-Lok Receptacle
Prise Lev-Lok MD
Receptáculo Lev-Lok
PK-A3126-10-02-0A