Evenflo Secure Step Manual Del Usuario página 4

1
C
B
2
C
D
E
A
90º
Floor
90º
Floor
T
IP
After positioning the latch bar, press
it against the wall to mark the pilot
hole locations.
A
Install Hinge Bar/Gate Door Assembly
• Place hinge bar
more than 1 inch (2.5 cm) above the floor.
Note: The hinge bar MUST BE straight up and down
(90º to the floor).
• With the hinge bar
the wall, drill two pilot holes (using the 9/64 inch
drill bit [3.5 mm]) 2 inches (5 cm) deep through
the hinge bar mounting holes
• Secure the hinge bar
provided screws
screwdriver when installing screws.
90º
Sol
Install Latch Bar
• Place latch bar
from hinge bar.
IMPORTANT: The latch bar MUST be the same distance
from the floor as the hinge bar. The latch bar MUST be
straight up and down (90º to the floor).
• With the latch bar
wall, drill two pilot holes (using the 9/64 inch drill bit
[3.5 mm]) 2 inches (5 cm) deep through the mounting
Sol
holes
E
• Secure the latch bar
provided screws
screwdriver when installing screws.
2
flat against the wall and no
A
properly positioned against
A
A to the wall with two of the
C . Use ONLY a handheld Phillips
90º
T
IP
Piso
After positioning the hinge bar,
press it against the wall to mark the
pilot hole locations.
D flat against the wall directly across
90º
properly positioned against the
D
Piso
.
to the wall with two of the
D
. Use ONLY a handheld Phillips
C
B .
90º