Cleaning The Everclear Doors (Optional) (Fig. 6); Lighting (Fig. 5 - Fig. 10); Bulb Replacement (Fig. 5 Rif. 13); Disposal Of The Cabinet - Arneg Pelican Manual De Instalacion Y Uso

Pelican
English

16.Cleaning the EVERCLEAR doors (optional) (Fig. 6)

ATTENTION!: EVERCLEAR doors are glass doors with a special transparent interior cover that
prevents condensation from forming.
To clean EVERCLEAR doors, keep to the following instructions:
- open and block the door
- carefully clean the interior with a soft, damp cloth appropriate to cleaning parts that may come
into contact with food products
- use neural detergents or soap and water
- change the cloth frequently
- close the door
- clean the exterior wall of the door using neutral household detergents or soap and water
- rinse with clean water and dry using a soft cloth
- DO NOT use abrasive products or solvents that can affect the door surface
ATTENTION!: DO NOT CLEAN THE DOOR INTERIOR WITH THE SAME PRODUCT
USED TO CLEAN THE EXTERIOR. DO NOT USE ANY ABRASIVE PRODUCTS OR SOL-
VENTS THAT COULD AFFECT THE INTERIOR DOOR SURFACES. DELLE PORTE

17.Lighting (Fig. 5 - Fig. 10)

For external lighting, a lighting system supplied with a modular fitting to be applied externally to the top
of the cabinet is available as an optional extra (Rif. 10).
For tank front lighting, a lamp can be installed on the handrail (optional) (Rif. 11).
OPTIONAL: For greater energy savings, the cabinet can be ordered complete with low
consumption LED lighting. This allows for:
- reduced lighting consumption
- reduced refrigerator load
- duration of lights: more than 6 years
- uniform lighting colour and intensity on all doors at all times
- improved lighting as temperature decreases.

18.Bulb replacement (Fig. 5 Rif. 13)

Replace the bulbs as follows:
- Disconnect the electricity supply from the cabinet.
- Remove fixing screws A from the protective casing.
- Remove caps B and protective casing C.
- Rotate bulb D by approximately 90° (until it clicks into place) and remove from the bulb-holder.
- Replace the bulb.
- Re-insert the casing and caps fixing them with the screws.
- Restore the electricity supply.

19.Disposal of the cabinet

The unit must be disposed of in accordance with your country's waste management legislation and in
respect of our environment.
This product is considered by current legislation as hazardous waste. It must therefore be collected
separately and cannot be treated as household waste nor sent to a landfill. Before disposing of the unit,
the coolant must be collected and the lubricant oil removed. The user is responsible for delivering the
product for disposal to the collection centre specified by the local authorities or manufacturer for the
recovery and recycling of materials. This product consists of 75% recyclable materials.
Materials used to build the cabinet:
- Iron tube:
- Copper, Aluminium:
- Galvanised sheet metal:
- Polyurethane foam (CO
- Tempered glass:
- Wood:
- PVC:
- Plastic laminate:
Note:All these operations as for transport and waste processing, should be performed by
34
lower frame and support structure
refrigeration circuit, electrical system and door frame
motor base, lower panels, varnished panels, base structure
): heat insulation
2
front glass and doors
side frames foamed tank
bumper
sides
05060104 01 01/09/2015