Troubleshooting - Snapper XD 1696864 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
POSSIBLE CAUSE
Polesaw fails to
The poles are not assembled
turn on.
correctly.
No electrical contact between the
polesaw and battery.
The battery pack is depleted.
The lock-off lever and trigger are not
depressed simultaneously.
The battery and power tool is too hot
or too cold.
Bar and chain
No oil in the oil tank.
running hot and
The discharge port is blocked by
smoking.
debris.
Inlet opening in inner oil tank is
blocked by debris.
The sprocket is stuck and clogged
with debris.
The chain and bar
Check chain tension for overtightened
running too hot
or loose condition.
and cannot cut.
Dull chain.
Chain on backwards.
Motor running, but
Motor stops after about 3 seconds.
cutting abnormal.
When using the polesaw under load,
it stops.
Battery is not charged.
Lack of bar and chain lubricant can
cause increased friction. Chain needs
to be properly maintained.
Incorrect battery storage temperature. Allow the battery pack to cool until the temperature drops to room
SOLUTION
Reassemble the poles according to the instructions.
To secure the battery, make sure the latches on the battery
compartment snap into place.
Charge the battery pack.
Press down the lock-off lever and hold it, then depress the trigger
to turn on the pole saw.
Refer to the battery and charger maintenance part in the manual.
Refill oil into the oil tank.
Refer to the manual to remove the bar and clean out the debris.
Clean the oil tank, and refill with clean bar and chain lubricant.
Clean the sprocket and refill with clean bar and chain lubricant.
Refer to Re-tensioning the saw chain in the manual.
Sharpen or replace the chain.
Refer to Replacing the Bar and Chain
assembly earlier in this manual.
Recharge the battery.
Release trigger. Restart the polesaw. Do not force the polesaw.
Refer to the manual for proper use.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
Make sure the polesaw always has bar and chain lubricant.
temperature.
21

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Xd sxd82zps

Tabla de contenido