Mitsubishi Electric CITY MULTI PLFY-WP-VFM-E Serie Manual De Instalación página 9

5. Electrical work
A
Fig. 5-4
Fig. 5-5
E
Fig. 5-6
5.1.1. Installing the i-See sensor and signal receiver
Before installing the grille, connect the junction wires included with the grille acces-
sories and place them in the connector box.
1 Remove the two screws securing the wire cover of the main unit, and then open
D
2 Route the wires of the i-See sensor and signal receiver through the wire inlets in
3 Remove the one screw securing the connector box cover, and then open the cover.
4 Place the junction wire connector in the connector box.
5 Install the wire cover and connector box cover.
C
When installing the covers, make sure that the wires do not get pinched.
B
as shown in the diagram. (Fig. 5-6)
D
the cover.
the electric component box as shown in the diagram and around the bushings on
the side of the main unit. (Fig. 5-4)
When routing the wires, open the clamp securing the grille junction wire, and then
secure the grille junction wire and the wires of the i-See sensor and signal receiver
with the clamp.
(Fig. 5-5)
Caution:
A Wire cover
B Connector box cover
C Connector box
D I-See sensor or signal receiver lead wire (Grille accessory)
E Band
9