Handset - Marmitek DOORPHONE 150 Modo De Empleo

HANDSET

16
21
1. The supplied Li polymer battery pack is already installed in the
handset. (To replace, press down the lock button
open the battery door, take out the battery pack and disconnect
from the socket .)
2. With the handset remaining switched off, place it onto the
charger stand.
3. Plug in the supplied AC power supply into an AC outlet and
connect its output plug to the DC jack
the charger stand.
4. The charging indicator
process. Adjust the position of the handset in the charger stand
in case this indicator does not light up. During charging, the
battery level icon
inside the icon will flash in turn.
5. The battery pack should be fully charged within 4 hours when
used for the first time. The charging indicator
steady green light. The icon
LCD if the unit is switched on.
DoorPhone 150
18
TO AC OUTLET
should light up red during the charging
will show up in LCD and the segments
will disappear or remain visible in
20
and slide
located at the back of
will show a
7