Operation - Marmitek DOORPHONE 150 Modo De Empleo

OPERATION

1. Switch on the handset with a long press (over 3 seconds) of the
Power ON/OFF button
case you want to switch off the unit.
2. The LCD screen will show up. In case the handset battery low icon
O appears and an alarm is heard, the battery has run down and
needs to be recharged by placing the unit onto the charger
stand. During charging, the segments inside the battery level icon
P will flash in turn irrespective if the unit is switched on or off.
To protect the battery, if the unit is not being re-charged when
the icon O
10 minutes.
3. To select the different methods of incoming call alerts, press and
hold the Volume Up/Down buttons
for 2 sec to enter the selection mode. Use the Volume Up
Down button
shortly press the Hang up button
and return to normal operation mode.
Depending on your selection, either one of the icons F to L will
be shown on the screen. Note that in case you select a
combination with vibrating alert, the battery will run down more
quickly.
4. During conversation, the sound volume heard through the
speaker
the speaker volume icon Q
Please note that the loudness of the door chime is fixed and
cannot be adjusted.
5. Make sure there is a power supply to the Door Unit (either by
12V DC or alkaline batteries). Now press the Call button
ding-dong tone will be heard and the Call indicator
to flash. Until a handset answers the call, the ding-dong tone will
be heard periodically, reminding the visitor to keep waiting. In
case there is no answer after 20 seconds, the Door Unit will end
the call by itself and the Call indicator
button
N.B. In case there are two Door Units (front gate and back gate),
only the unit whose call button
a call signal to the handset, the remaining unit will remain in
standby mode until the conversation is over. If its call button
is pressed during this period, a "Be-Be" sound will be heard
16
shows up, it will be switched off automatically after
to choose one of the seven alert methods,
can also be adjusted using buttons
to initiate the call again.
. Press the same button again in
&
to confirm your selection
will change correspondingly.
will go off. Press the Call
is pressed first will send out
simultaneously
& and
, a
will start
© MARMITEK
or