Output Modes - Crouzet 87 620 Manual Del Usuario

87 620
p p p

2.2 - Output modes

The outputs operate in correspondence with the pulse counter.
The outputs are monostable or bistable according to the configuration set.
In operation with resetting mode:
- If the preset value P1 is reached, the output OUT1 is activated.
- If the preset value P2 is reached, the output OUT2 is activated.
Zero reset mode or original mode
Static reset
! ( *
Dynamic reset
" .
Reset mode
Upcounting
 
Downcounting

The outputs OUT1 for P1 and OUT2 for P2 are available as changeover
outputs and PNP solid-state outputs.
They can be programmed as bistable or monostable with adjustable
durations. The state of the outputs after a power cut can be restored by
configuration.
If OUT1 is programmed as bistable, it disappears when signal OUT2 is sent.
If the output OUT2 is set as bistable, it can only be reset manually or
electrically.
52/231
Counting
Reset
Display
Counting
Reset
Display
Counting
Reset
Display
Operation with electrical, automatic or manual Reset
E.g. P2 = 8
Counting
Reset
Display
Operation with electrical, automatic or manual Reset
12 - 2005