Publicidad
To treat a very soft surface, there is a very handy method
to 'bring the particles to the surface'. This is done as fol-
lows: wet the already sanded surface with a cloth or
sponge and let it dry well. Some wood fibres will swell up
more than others, which leads to a rougher surface than
before. Now the higher particles are treated with fine
sanding paper, the result is a remarkably smooth surface.
This method should not be applied with varnished wood,
however, because the varnish may come loose because
of the moisture.
7. MAINTENANCE
While maintaining and cleaning the machi-
ne pull the plug from the mainssocket. Never
!
use water or other agressive liquids to clean
the machine. Clean the machine by brushing
it with a brush.
PERIODIC MAINTANCE OF THE BELT SANDER
WILL PREVENT UNNECESSARY PROBLEMS!
1. Keep the ventilation slots of the machine clean to
prevent overheating of the motor.
2. There is no need to lubricate the transport rollers of
the machine.
8. MALFUNCTION
Below we have listed a number of possible causes and
corresponding solutions in case the machine does not
function as it should:
1. The electromotor gets hot.
The cool ventilation slots in the motor are stopped up
with dirt:
- clean the cool ventilation slots.
The motor is defective:
- Have your sanding machine repaired or checked at
your local Ferm dealer.
2. The connected machine does not work.
Interruption in the mains connection:
- Check mains connection for fracture;
- Have your sanding machine repaired/checked at your
local Ferm dealer.
4
■
ClEl
( GB )
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in conformity with the following
standards or standardized documents
EN61029-1
EN55014, EN61000-3-2, EN61000-3-3, EN55104
in accordance with the regulations:
89/392/EEC
73/23/EEC
89/336/EEC
from 01-03-2003
GENEMUIDEN NL
W. Kamphof
Quality department
Ferm
Ferm
Fig. 2
Fig. 3
Fig. 1
Fig. 4
33
Publicidad
